Introducing the Anvil FRT
Click here to for orders on ANVIL FRTs
Brought to you exclusively by Pembleton and Sons
Product Overview:
This is a hammer and safety swap for a Milspec trigger allowing the shooter to rapidly engage the trigger, this works in conjunction by the hammer hitting a custom disconnector (designed to perform the reset) during cycling allowing it to reset the trigger, then once the trigger is reset the safety will rotate locking the trigger into safe mode. Only when the bolt carrier is back into battery does the safety then rotate back to the fire position, allowing the trigger to be pulled thus repeating the cycle, this is a semi auto trigger as it fires one round per trigger pull and interacts with a disconnector before resetting. An h3 buffer, anti-walk pins and rounded safety detent are the only things required outside of the included parts and are recommended for proper function of the system, h2 buffers will also suffice but you will need to make sure your system is tuned for this setup SILENT CAPTURE BUFFER SYSTEMS WILL NOT WORK. you will need a full auto bolt carrier or you will not get function of the frt!
kit contains 1x hammer 1x disconnector 1x safety 1x lever 1x non rounded detent
manufactured from ar500 steel for the hammer and disconnector, the lever is 304 stainless and safety is a2 tool steel.
we recommend a bkings firearms trigger with a slight angle at the rear as a trigger with a 90 degree rear profile will not work BKF Ar15 Mil Spec Trigger BKF Ar15 Mil Spec Trigger
this is a pre order item, batch 3 is currently shipped, batch 4 will ship at the end of January all orders after Christmas 2024 are in batch 4
10% restock fee
we cannot guarantee function in 80% or 3d printed lowers as tolerances can vary, this is designed for milspec ar15 lowers. some lowers have a slight trigger pin tolerance difference, and the disconnector can be slightly modified to prevent bolt hangups as the trigger may be sitting a fraction of an inch too high. to fix this take note of where the disconnector is interacted with by the hammer and use a file to bring the height of the area slightly lower so that the bolt can clear properly.
this should only be installed by a qualified gunsmith, we are not responsible for improper installation. all earlier versions of the anvil frt that did not include a disconnector and updated hammer if ordered are eligible for an updated replacement kit at no cost to you, we will need an order number to replace the original kit.
